Defining basement waterproofing systems.
The basement waterproofing systems and their working. To answer that question, let’s first look at historically conventional basement waterproofing and how it is supposed to work.
If you imagine how a basement is first built, when the house it is sited in was first conceived, then basically the following happens:
A big hole in the ground is dug, the footer or foundations are laid, the walls of the basement are built and then the rest of the house follows.
The important point to note is the first one in the list above – that big hole in the ground. When basement walls are constructed there is an area outside the walls that must be filled. Loose backfill is what is used to fill this void. No matter how well the backfill is compacted, it is still backfill and water seeks the places of little resistance.
This area is going to have water constantly seeping into it. The conventional basement waterproofing system provides some form of drainage pipe for this water to drain away, but the problem with this is that often these pipes get silted up. It’s natural enough, the water is bringing all sorts of suspension with it. Allowing these pipes to fill up, can result in an overload of the system, which can be catastrophic to the basement’s outside walls. If there are crevices in the walls, water will push through even if the basement walls are waterproofed.
This kind of situation is persistent because the tubes that should drain the excess water eventually deteriorate.
A lot of the time a huge mistake is made by not providing access to these pipes. To keep water out of a basement, waterproofing is also applied to the external walls. This is also called a tanked system.
If you want to find out if you have water inside the concrete block of your walls simply tap a hole into the concrete block, near the floor, and see if you have water coming out of this block then you may want to consider a drained cavity waterproofing system this system drains the water from your walls, much the same way you just did, by adding drain holes in the bottom blocks that allows those areas to drain into a type of interior french drain system. Water is controlled, collected and allowed to flow through hidden drainage channels either to natural drainage or to a sump pump where the water is removed away from the property.
Basement waterproofing systems are superior because they are installed internaly, have easy access ports for removing silt, and can be installed in basements where other methods have failed.
So to summarise, a good basement waterproofing system will:
- usually be a permanent or long-term solution
-stop water through the floor and walls
- not disturb landscaping, decks, patios, driveways, etc
-an approved method by home loan lenders
-more affordable than other methods
You want to be sure to choose a reliable waterproofer for your home, keep in mind that it will greatly increase the value by far more than what you initally paid.
While you are getting the house made you need to realize that waterproofing is more of an investment in the value of your house rather then an expense.
Start using the waterproofing system for your basement with no hassle or hard work. If you wish the the basics and ensure that you have a hassle free and cheap experience, visit As with most companies you can now get information on basement waterproofing systems via an online website.
No related posts.
Related posts brought to you by Yet Another Related Posts Plugin.